Precautions for use of Dongguan blow molding equipment
Source:admin
Browse:次
Release date:2020-01-06
1. Before using the blow molding equipment, please read the instruction manual of the injection molding machine used, understand the structure and transmission process of each machine, understand the use of the related control components and components, and be familiar with the oil circuit diagram and electrical principles.
2. Check the tightening of each fastening part in detail. If there is looseness, tighten it immediately.
3. Check the buttons, electrical switches, operating handles, handwheels, etc. for damage or psychic phenomena. Before driving, each switch handle or button should be in the disconnected position.
4. Check whether the safety door slides flexibly on the track and whether it can touch the limit switch at the set position.
5. Check whether the fuel tank of the blow molding equipment is full of hydraulic oil. If the oil is not filled, the fuel tank should be cleaned and tidy, and then the specified type of hydraulic oil is injected into the tank from the oil filter, and the oil level reaches the upper and lower limit lines of the meter. intermediate.
6. Inject lubricating oil into all oil cups and lubrication channels to make them lubricated.
7. Check whether the power supply voltage is consistent with the rated voltage of the electrical equipment. If they are not adjusted accordingly, make them the same.
8. Check the clean condition of the working table of the second machine, and remove all kinds of tools and sundries used in the debugging of the equipment, especially the transmission part and sliding part.
9, check the blow molding product equipment hopper for foreign matter, fill the hopper with material.
- Methods to avoid defects in injection blow
- Essentials of Design and Processing of Blow
- How to solve the plastic shrinkage problem
- What are the precautions for delivery servi
- Causes of fading of blow molded products
- Solution to color difference of blow molded
- Introduction of wall thickness requirements
- Dongguan blow molding product design safety
- What about the payment process?
- How to control the color difference of inje
- What are the maintenance methods for blow m
- What are the characteristics and features o